Hỗ trợ trực tuyến
+84-24-3628 2225
Giám đốc khối Kinh doanh
+84988484738
info@amcvietnam.com.vn
Sales Executive
+84981115208
sales2@amcvietnam.com.vn
Export Sales Manager
+84942059606
sales1@amcvietnam.com.vn
Video Clip
» AMC Viet Nam Plywood 4
» AMC Viet Nam Plywood 3
» AMC Viet Nam Plywood 2
» AMC Viet Nam Plywood 1
Thống kê
- Trực tuyến: 2
- Lượt xem theo ngày: 179
- Lượt truy cập: 2510966
|
I. DEBARKING
First of all the log is debarked to ensure that it has the good surface for peeling
|

|
II. PEELING AND CLIPPING
The log is sawn by peeling through rotation against a lathe blade, which lies against the length of the log. This produces a ribbon of veneer. The ribbon is cut to size by a clipping machine.
|

|
III. DRYING
The veneer goes through a drying machine to reduce its moisture content. This facilitates the bonding of the veneer afterwards
|

|
IV. GLUING AND JOUNTING
Small parts of veneer can be jointed into full-size sheets. This can be done by edge gluing, stitching or gluing paper adhesive tape. Afterwards, the veneers are sorted into different quality grades.
The veneer plies are assembled ("lay-up") through cross bonding: with the grain of each veneer at 90¡ to the adjacent veneer. They are glued together with a synthetic resin adhesive. The gluing process is supervised closely.
|
.jpg)
|
V. PRESSING The lay-ups are heated and pressed. A cold pre-pressing is applied to improve the quality and makes the pressing easier. Hot-pressing is done in high-temperature hydraulic presses.
|
VI. TRIMMING, SANDING (And Filming) After the pressing, the panel is trimmed and, if necessary, surface defects are filled or repaired. Subsequently, most plywood is sanded, then cover face and back wood veneer (or film) to make a final plywood.
|
VII. PACKING AND LOADING
Standard packing or as required
Loading into containers by forklift.
|

|
|